Page 5 of 5

Re: Suggestions for a LED setup

PostPosted: Sun Dec 11, 2011 11:38 am
by AfganBerry
Yeah would be alot of fun to play around and just be creative, see what you come up with. I mean some of the best things on the planet have been a result of someones screw ups lol. That is what I would really be doing if I was to take on that challenge. I think for now I have my hands full with my current situation. But my goals would be to play around and have fun.

Sounds like an interesting mix you had there, distinct smell, too bad you no longer have it available.

Re: Suggestions for a LED setup

PostPosted: Sun Dec 11, 2011 1:45 pm
by SisterMaryElephant
It became a little more "skunky" during flower but during veg I've never smelled anything like it before or since. It's not likely that I'd be able to recreate it and it is a lot of work but my next Frankenstein might even be better... ;)

Re: Suggestions for a LED setup

PostPosted: Wed Dec 14, 2011 12:59 pm
by AfganBerry
Yeah I have noticed that even in veg stage that the Mazar is alot more of a "skunky" smell compared to the blueberry which smells like blueberry lol.

Re: Suggestions for a LED setup

PostPosted: Wed Dec 14, 2011 4:03 pm
by SisterMaryElephant
Sure, you bet, even after harvest and curing, smells and tastes can change. :D

Re: Suggestions for a LED setup

PostPosted: Fri Dec 16, 2011 5:41 pm
by AfganBerry
Yeah I was just abit shocked at such a noticable difference at early veg stage. I am wondering how much of an impact that will be once they are actually in bloom. I have a nice big bucket of ONA on stand by lol.

Re: Suggestions for a LED setup

PostPosted: Fri Dec 16, 2011 8:53 pm
by SisterMaryElephant
My experience with skunk genetics says that it should get a LOT more skunky as it gets older. ONA does work well though, I just put a little in a plastic plate near the fans and renew as needed. :D

Re: Suggestions for a LED setup

PostPosted: Sat Dec 17, 2011 7:46 am
by AfganBerry
Lol great I will be stinking up the place. I think between the carbon filter, Ona, and a bucket of mr Clean with an airraitor pump in it I will be ok on smell.

Re: Suggestions for a LED setup

PostPosted: Sun Dec 18, 2011 4:57 pm
by SisterMaryElephant
Yeah, even the carbon filter should be enough (if properly sized and maintained) but adding ONA to the mix should take care of even the stinkiest skunk genetics. ;)

Man I wish we could upload odors on the Internet. :D