Page 5 of 5

Re: My first grow

PostPosted: Mon Jan 09, 2012 7:07 pm
by SavageBelief
Ok so I'm running out of vertical room. I'm keeping the light right on top of the plants but I still have to raise it every couple days. They're about 3' tall and I only have about 2' left before I can't raise the light anymore. I know I don't have to worry about them growing into the light but then the tallest one blocks out the light for the rest.

Re: My first grow

PostPosted: Tue Jan 10, 2012 5:00 am
by SisterMaryElephant
If I remember correctly, they've been in flower for 3 or 4 weeks, right? Most of the flower stretch should be already done so you should be OK. Not much can be done about the bigger one if you can't relocate it or move the light. Next run, if you use clones from the same mother, they should all be close to the same size. You may want to veg a little less, next time, if height ends up being an issue. The more you grow with your new system the more bugs you'll iron out.

Re: My first grow

PostPosted: Sat Jan 14, 2012 8:58 am
by SavageBelief
TRAGEDY!

My pump went out last night. Walked in to a wet floor and a broken hose. Getting a new one this morning an keeping the roots wet.

Re: My first grow

PostPosted: Sat Jan 14, 2012 11:43 am
by SavageBelief
Ok crisis averted. New pump is installed, an Eco 396, and it's more easily replaced if something goes wrong in the future.

Also, since I had to have the lights on anyway, I snapped a few more pics :D

Re: My first grow

PostPosted: Sat Jan 14, 2012 11:47 am
by SavageBelief
Image

Re: My first grow

PostPosted: Sat Jan 14, 2012 11:48 am
by SavageBelief
Image

Re: My first grow

PostPosted: Sat Jan 14, 2012 11:49 am
by SavageBelief
Image

Re: My first grow

PostPosted: Sat May 05, 2012 7:24 am
by Caregiver
SavageBelief wrote:The only problem I have is in the upper left corner..

The whole top of that plant is yellow. Not sure what to do...
Image


Did you ever figure out what caused the yellowing that you experienced? I wondered if it was light getting to your roots before you covered the unused holes.